NOTE
For MEDRAD Mark 7 table mount and ceiling mount, rack connected to C2 cabinet is
located in technical room.
ECG Acquisition kit
The ECG Acquisition kit allows the connection of an ECG device (such as GE’s MacLab, CardioLab or
ComboLab) to the system. The ECG Acquisition kit consists of a Hubican and Physio modules and their
associated cables; it is compatible with ECG devices installed in the Exam Room and in the Control Room.
2.1.3 Dimension Drawings
Refer to this section for the dimensional drawings of the components of the systems with 21 & 31 cm
detector. This section also contains the Frontal Gantry, Lateral Gantry and patient table sweep volume
curves. These systems include:
Frontal and Lateral Positioner, Omega Table, C2 Cabinet, C1 Frontal Cabinet / C1 Lateral Cabinet, 1 kVA
Cabinet UPS, 3 kVA LDM UPS, Chillers, Optional Fluoro UPS and PDB (main disconnect). In addition, refer to
this section for Positioner/table relative position drawings.
Table 2-6
Product or component QTY Illustration
Exam Room
Frontal Positioner - Side View
1
Figure 2-5
Frontal Posi-
tioner dimen-
sions - Side
View on page
41
Frontal Positioner - Top View Figure 2-6
Frontal Posi-
tioner dimen-
sions - Top View
on page 42
Frontal Positioner - Front View Figure 2-7
Frontal Posi-
tioner dimen-
sions - Front
View on page
42
Lateral Positioner - Side View
1
Figure 2-8 Lat-
eral Positioner
dimensions -
Side View on
page 43
Equipment Requirements
5750182-1EN 3
Innova
TM
IGS 6
37
To Next Page
Loading...