Usea sewing needle or twist-tie
to unclog flTesmall hole in flTe
burner head.
Burner Caps and Heads
NOTE:Beforeremovingtheburnercaps
andheads,remembertheirsizeand location.
Replacethemin thesamelocationafter
cleaning.
Burner caps
I,ifl off when cool. _.V_sh burner caps
in hot, soapy water and rinse with clean
water: You may scour with a plastic scorning
pad u) renlove bm'ned-on toed particles.
Burner heads
For i)roi)er ignition, make sm'e tile
small hole in tile section that fits over tile
electrode is kept open. A sewing needle
or wire twist-tie works well to tmclog it.
Theslits in the burnerheads must bekept clean
at a// times.
Clogged or dirty 1)/m_er ports or electrodes
will not allow file b/m_er to operate properl):
An) spill on or are/rod an electrode must
be carefifllv cleaned. %_ke care to not hit an
electrode with anything hard or it could
be damaged.
You should clean tile bm'ner caps and
bm'ner heads routinely, especially alter bad
spillove_s, which could clog the openings
in tile bm'ner heads. I.ifi offwhen cool.
To remove burned-on fi)od, soak tile
burner heads in a solution of mild liquid
(lete_gent and hot water lot 20-30 minutes.
For illoi'e Sttlbboi'n stains, rise a toothbrtlsh.
After cleaning
Before putting tile bm'ner caps and heads
back, shake out excess water and then (h_'
them thoroughly by setting in a warm oven
ti)r 30 minutes.
NOTE"Donot usesteelwoolorscouringpowders
tocleantheburners.Thiscandamagetheburners
andelectricallyshorttheelectrodes.
ge.com
Replacement
Rei)lace bm'ner heads over tile ele(trodes
on the cooktop, in tile correct locations
according to flmir size.
Mediumhead Smallhead
o
Largehead Extralargehead
Make sm'e tile slot in tile burner head is
positioned over the electrode,
Rei)lace tile matching size caps onto
the heads.
Mediumcap Smallcap
o •°-
....... Frontof range
LargecapExtra largecap
Make sm'e that tile heads and caps are
replaced in the correct locations.
33
I
i!!!iliiiiiii
/iiilliiii{iii_
m
=:
g
g
}
To Next Page
Loading...
