,O
,O
{
,O
,O
iii;;{!!!iii_i!iiiiiiiiiiiii_i
iiiiHl! iiiii
m
ea
Beforeyoucall for service...
Troubleshooting tips
Oven light does not work
Possible Causes
Light bulb is loose or defective.
Plug on rm_ge is not completely
hlserted in the electrical outlet.
What To Do
• Tighten or replace the bulb.
• Make sure electrical plug is plugged into a live, properly
grounded outlet,
Oven will not self-clean The oven temperature is too • Pdlow the range to cool to room temperature and
high to set a self-cleml operation, reset the controls.
Oven conlrols improperly set. • See the Using the self-cleaning oven section.
"Crackling" or This is the somld of the • This is normal.
"popping" sound metal heating and cooling
during both the cooking and
cleaning functions.
Excessivesmoking Excessive soil. • Touch the CLEAR/OFFpad. Open the windows to
rid the room of smoke. _4ait tmtil the LOCKEDDOOR
light goes off. _4]l)e up the excess soil and reset the
clean cycle.
Oven door will not open Oven too hot. • _Mlow the oven to cool below locking temperature.
after a clean cycle
Oven not clean after a Oven conwols not properly set. • See the Using the self-cleaning oven secti(m.
clean cycle
Oven was heavily soiled. • Clean up hea\ T spillovers befm'e starting the clean
cycle. Heavily soiled ovens may need to sell:clean
again or fin" a longer l)eriod of time.
"LOCK DOOR" flashes The self-clean cycle has been • Close the oven door.
in the display selected but the door is not
closed.
LOCKEDDOORlight The oven door is locked • Touch the CLEAR/OFFpad. Allow the oven to cool.
is on when you want because the temperature
to cook inside the oven has not
dropped below the
locking temperature.
"F--andanumberor You have a ftmction error code. • Touch the CLEAR/OFF l)ad._Mlow the oven to cool tbr
letter" flash in the display one h(>ttL Put the oven back into operation.
If the function code repeats. • Disconnect all power to the range fin" 5 minutes
and then reconnect power. If the traction error
code repeats, call fin" service.
Oven shelves are The nickel shelves (if so equipped) • Apply a small amount of vegetable oil to a paper
difficult to slide were dem_ed in a self-clema cycle, towel and wipe the edges of the oven shelves with
The gray porcelahl-coated shelves the pal)er towel. Do not spray with P;mf" or other
(if so equipped) were improperly lul_ricant sprays.
cleaned.
"Probe" appearsin
thedisplay(somemodels)
This is reminding you to enter a
probe temperature after plugging
ha the probe.
• Enter a probe temperatm'e.
g2
To Next Page
Loading...
