MA-041 – DGA 900 Plus - Installation & Commissioning Manual - Rev 1.1 4-Mar-22 Page 62 of 99
Figure 9-40: Configure > Save last measured data > as “load” calibration
Select File > Save As and type the filename calibLoad as shown in Figure 9-41 to
save the data in the folder created in Section 9.8.2.1 for this Bushing Adaptor.
Figure 9-41: Save As “calibLoad”
9.8.2.2.4 Adaptor-only Test
Connect the clips to the Bushing Adaptor using the short cables in the adaptor’s
connector as shown in Figure 9-42.
To Next Page
Loading...
