MA-041 – DGA 900 Plus - Installation & Commissioning Manual - Rev 1.1 4-Mar-22 Page 83 of 99
Figure 10-14: TapPositionCalibration.cfg
6. Click the Generate Group Definition File button to create the ‘OltcGroups.cfg’
file.
In the dialog box, browse to the folder location for the configuration file and click
OK.
A message box confirms with the message ‘File creation complete’ when the
configuration file is successfully created in the specified location. Click OK.
Browse to the folder location of the ‘OltcGroups.cfg’ file.
Use a text editor, such as Notepad, to open the ‘OltcGroups.cfg’ file and verify that
the file looks similar to the example shown in Figure 10-15 i.e. that the file is not
blank or corrupt.
To Next Page
Loading...
