GE KTD-405 - Operating Your Keypad

KTD-405/KTD-405A/KTD-405-2D Controller Keypad
User Manual
34
Remote programming
At the ENTER PROGRAMMING CODE menu, press 9-5-1-seq to display the REMOTE PROGRAMMING
menu, which allows you to program devices such as cameras and VCRs, as shown in the tree in Figure 51.
Figure 51. Remote programming menu tree
A few things to note about your choices within this menu tree:
• You must select the zone before entering programming mode.
• Pressing 3 in standard Digiplex mode prompts you to enter a camera site number.
• Pressing 3 in zone mode prompts you to enter a camera number in the current zone:
Note: Supervisors may disable remote programming.
ENTER MONITOR
NUMBER:
SEE MONITOR FOR
MENUS
1=SWITCHER/MPLX
2=ALARMS
3-CAMERA
ENTER CALIBUR
ADDRESS:
ENTER MONITOR
NUMBER:
SEE MONITOR FOR
MENUS
SEE MONITOR FOR
MENUS
1=440 2=CALIBUR
3=340/348BACK
SEE MONITOR FOR
MENUS
SEE MONITOR FOR
MENUS
ENTER CAMERA SITE
NUMBER___BACK
Standard Digiplex mode
Zone mode
SEE MONITOR FOR
MENUS
ENTER ZONE XCAMERA
NUMBER__BACK