8
Listing of second level Parameters
Below a listing of the Parameters:
• Battery type
• Floating voltage adjust
• Battery capacity
• Battery charge current limitation
• Number of Battery cells
• Autonomy (Backup) time in Minutes
• Stop operation time in Battery discharge
• Bypass locked (enable / disable Bypass)
• Tolerance of Mains Bypass voltage
• Programming of Automatic Battery test
• Manual Battery test
• Commands (Inverter ON) Local, Remote, Both
• Input filter (Rectifier input voltage)
• Mains filter (Bypass voltage)
• Sync filter (Alarm not synchronizerd)
The delay time , in seconds, installed in one of the
above Parameters has effect on the signals from the
Panel, the events memory and the Customer Interface
• Programming of the 6 output relays on the Customer
Interface.
• Programming of the 2 input relays on the Customer
Interface.
See the operating manual for possible programming
signals, or scroll simply through them.
• Inverter output voltage (220, 230, 240 Volt)
To Next Page