Preparing for an Exam
4-26 LOGIQ 7 Basic User Manual
Direction 2392206-100 Rev. 1
User-Defined Application Presets (continued)
5. To view/edit the parameters for the user-defined preset,
press Utility --> Imaging.
If you change the settings for this application, make sure to
save the changes via Save --> Overwrite (user application).
Figure 4-24. Imaging Presets for User-Defined Application
NOTE: If you select Reload Factory Defaults for the User-Defined
application that you created, the settings for this user-
defined application revert back to the factory settings for the
exam category and application it was based upon.
NOTE: Currently, there is no way to delete a user-defined
application.
To Next Page
Loading...
Need help?
General
