Option 1 Installation
ZKT36 Trim Kit
3/4 " Custom P_nds
Step 5
Adjust
grille panel
height
The refrigerator is shipped with the top case trim
secured at the 83" refrigerator height.
• Loosen 2 screws on both sides and raise the top case
trim to meet soffit height, from 83" to 84-1/2".
• Tighten all 4 screws.
Important: Maintain 1-1/2" min, gapbetween top of doors and
bottomof grille panel,
TopCa __s_Tdm _ _l . ?
/J
/
Step 6
Secure 3/4"
panel to
grille panel
support
• Secure the new grille panel support to the back side
of the 3/4" panel with #6 screws.
• Be sure the lip on the support panel is over the top of
the wood panel.
PaHel Support
/
Step 7
Install
grille panel
1/16" 1
\ /
• Install four of the six larger under cut screws such
that the top of the screws are 1/16" from the surface of
the support.
• Attach the assembled panel to the grille frame by
inserting the four protruding screws into brackets
located on each side of the grille frame.
/
30
To Next Page
Loading...
