ZKHSS1 for 1/4" Panels
Tubular Stainless Steel [-[nz_ctles
This kit provides for the installation of Stainless Steel custom
handles on 1/4"thick decorator door panels. Thedoor extru-
sions allow these custom handles to be secured to the door
structure, rather than to the custom panels, This kit contains
all the necessary parts for dispenser and non-dispenser
models.
Toolsand materials required:
•#2 Phillips screwdriver
• Drill and 1/8",9/32"bits
• Custom door panels
• Safety glasses
• Center punch
• Masking tape
• Hammer
• Pencil
• 1/2"thick 12"x 12"min, piece of plywood
to protect floor when drilling
• For stainless steel panels wear gloves to
protect against sharp edges.
PartsList:
A. Fresh food door extrusion
B. Freezer door extrusion
C.2 Stainless tubular handles
D. 10Spacer rings (for Stainless panels ONLY)
(8required, 2 extra)
E.8 Handle standoffs
F.10Screws for mounting handle standoffs
(8 required, 2 extra)
G. 10Set screws (8 required, 2 extra)
H,3/32"Allen wrench for set screws
Note: It is best that 2 people install this kit.
D
Giiiii
E
H
Step 1:
Remove
Handles
• Open doors to 90°. Remove the screws from the full-
length handles of both doors.
• Retain screws, discard handles.
• Locate the 2"x 2" adhesive foam pads packed with
the refrigerator. Apply pads to the doors as shown.
Corner pads should be as close to inside corners as
possible.
[]
S
E
Note: If a custom collar is to be used,order ZWCD1Trim Kit
for 36"and 421'wide models, OrderZWCD2for 481'wide
models,
38
To Next Page
Loading...
