Chapter 8: System Hardware Overview
5495975-1EN Rev.9 8-52
© 2013-2017 General Electric Company. All rights reserved.
3. Table Top Positioning
Foot Pedals
This pedal allows you to move the table in all directions: longitudinally and
transversely. This is known as a floating tabletop.
Press the pedal twice and hold down to move the table top.
4. Down Pedal The Down pedal lowers the digital table down.
Press the pedal twice and hold down to lower the table.
5. Up Pedal The Up pedal raises the digital table up.
Press the pedal twice and hold down to raise the table.
6. Table Lock Control
Buttons
There are two lock buttons located on the left and right sides of the table,
near the head and foot of the table. They are used to prevent the table up-
down and tabletop movement. The lock is engaged when the button is lit.
7. Emergency Stop
Buttons
There are two Emergency Stop buttons located on the left and right sides
of the table. These buttons are used to remove power from the table in an
emergency. Refer to Chapter 4: General Information
-Emergency Stop
(p. 4-9) for more information.
CAUTION For Digital table, when the Emergency Stop button has
been activated, the table will move longitudinally only.
The table is not locked into position. Exercise extreme
caution with your patient when this happens.
8. Detector Tray
Override
The Detector Tray Override is used for receptor placement if auto-tracking
fails.
Table 8-13 Digital table components
Item Description
To Next Page
Loading...
