GE Optima XR646 - Delete Procedures; Delete a Single Procedure; Delete All Completed, Discontinued, and Local Procedures

Chapter 9: Worklist
5495975-1EN Rev.9 9-12
© 2013-2017 General Electric Company. All rights reserved.
Delete Procedures
You may remove procedures from the Worklist individually or all completed, discontinued, and locally
added procedures at once.
The [DELETE] button is able to switch between individual delete or delete all.
Note: Deleted procedures cannot be recovered or “undeleted.”
To switch the button between “Delete” and “Delete All”:
1. Click on the small arrow on the right side of the button.
 A list appears with the available actions.
Figure 9-9 Delete button options
2. Click the action you want to perform.
 The system performs the action and the button name changes to the selection you made. The but-
ton will perform the selected action each time it is clicked until you change it.
Note: [DELETE] or [DELETE ALL] does not remove procedures from the RIS or HIS. [DELETE] or [DELETE
ALL] does not remove any exam images from the image database.
Delete a Single Procedure
1. Select the procedure to delete.
2. Click [DELETE]. If necessary, switch the button to [DELETE].
 A message appears: “Are you sure that you would like to delete the selected items?”
3. Click [OK] to delete the procedures.
 [CANCEL] retains the procedures and the Worklist appears.
Delete All Completed, Discontinued, and Local Procedures
1. Click [DELETE ALL]. If necessary, switch the button to [DELETE ALL].
 A message appears: “All Completed, Discontinued, and locally scheduled exams will be deleted
from this list. Any suspended exams will need to be individually deleted.”
2. Click [OK] to delete the procedures.
 The selected procedures are deleted and the Worklist appears.
 [CANCEL] closes the message, retains the procedures, and takes you back to the Worklist.