Chapter 11: Image Viewer
5495975-1EN Rev.9 11-22
© 2013-2017 General Electric Company. All rights reserved.
Change Pointer Controls
The pointer control buttons (Figure 11-15) change the action of the pointer when it is clicked and
dragged on an image.
Figure 11-15 Pointer control buttons
The pointer controls allow you to perform other functions that are not available in any other tool panel.
Follow this process to change the pointer controls. Table 11-8 describes the action of each control.
1. Select the image to act upon, if necessary.
2. Click the pointer control to use.
3. Click and drag the pointer on the selected image.
Table 11-8 Pointer Controls description
Tool Description
Select Image When viewing multiple images, selects the image to act upon. This is
the default pointer behavior.
Pan Image Moves the image within the viewing area.
Image Magnifying
Glass
Shows a small part of the image at 3 times magnification.
To Next Page
Loading...
