Chapter 13: Advanced Applications
5495975-1EN Rev.9 13-22
© 2013-2017 General Electric Company. All rights reserved.
Figure 13-19 Define top of coverage area
14. Aim laser light at the bottom of the desired image field (Figure 13-20).
You may do this by either angulating the tube or by keeping the tube at 90° and moving the column
vertically.
15. Press [FOOT] on the OTS control screen (Figure 13-20).
Figure 13-20 Define bottom of converge area
Note: Press [RESET] on the control screen (Figure 13-21) to erase the COI, HEAD, and FOOT settings.
Figure 13-21 [RESET] button
16. Adjust the lateral collimation and ensure the OTS angle is set at 90 degrees.
To Next Page
Loading...
