Chapter 15: Preferences
5495975-1EN Rev.9 15-42
© 2013-2017 General Electric Company. All rights reserved.
The Add View (or Edit View) screen (1 of 2) appears.
4. Type a View Name. Do not use spaces. Use underscores ( _ ) to separate words.
5. From the Position View After drop-down list, select the placement of the view within the exam.
6. Select the Acquisition Type.
Available options are:
– Standard
–Bone
–Soft Tissue
– Image Pasting (if enabled on your system) (Refer to Chapter 13: Advanced Applications
-Auto
Image Paste (p. 13-13) for more information.)
– VolumeRAD (if enabled on your system) (Refer to Chapter 13: Advanced Applications
-Preferences
(p. 13-31) for more information.)
7. Check if horizontal flip is to be applied when displaying the image.
8. Select the Anatomy.
Note: The selected anatomy will determine the image processing for the view. Be sure to select the
appropriate anatomy for the body part imaged.
9. Select the most appropriate View (AP, Lat, etc.).
The selected anatomy determines which views are available.
10. Select the Laterality:
To Next Page
Loading...
