Chapter 15: Preferences
5495975-1EN Rev.9 15-43
© 2013-2017 General Electric Company. All rights reserved.
The selected anatomy determines which laterality options are available.
– If the anatomy is unpaired, then Unpaired is the only available selection.
– If the anatomy is paired, the available sections are: Both, Left, and Right.
– Paired anatomy enables the Patient Side control on the Image Acquisition screen. Refer to
Chapter 10: Image Acquisition
for more information.
11. Select the Default Position:
The selected anatomy determines which positions are available. In general:
– If the anatomy is unpaired, the selections are Head Down or Head Up
– If the anatomy is paired, the selections are Digits to Back, Digits to Feet, Digits to Front, Digits to
Head.
12. Click [NEXT].
The Add View (or Edit View) screen (2 of 2) appears.
13. Select all Patient Sizes you want available for the view. The default size will automatically be selected.
14. Select Receptors and Modes for each selected receptor.
Note: The available receptors that appear on this screen depend upon your system’s configuration. Not
all systems will have the receptors shown here.
15. Select the Default Receptor.
16. Click [NEXT].
To Next Page
Loading...
