– 13 –
Caution: In the following step, to prevent damage
to door and electronics, carefully place the door in a
protected location.
Note: The lower door hinge pin and hinge are keyed
and must be matched correctly for the door to self-
close properly. For proper installation later, please
follow the directions carefully.
9. Remove tape, and keeping the door as vertical
as possible, open the door to 90 degrees+, then
lift straight up from the bottom hinge.
L
I
F
T
To install the left fresh food door:
Note: To close correctly to the cabinet, the hinge pin
must be properly aligned with the lower hinge.
1. With the left side door at 90 degrees+ to the
front of the case, lower the refrigerator door
onto the center hinge. Ensure that the door and
hinge align correctly.
2. Rotate door closed and make sure the pin
on top of the articulating mullion engages
the guide located at the top of the fresh food
compartment.
3. Install top hinge, water line, strain relief, ground
wire, and connect wire harnesses. Install hinge
cover.
If the door will not close after reinstalling, it will
be necessary to remove and turn the door upside
down, and check alignment mark and arrow. Rotate
door-closure mechanism hex-head screw to align
mark and arrow, and reinstall door.
Note: Turn the closer pin on the right door
counterclockwise and the one on the left door
clockwise.
Using a 5/32-in. Allen wrench (some may be 1/4-in.
hex), align the parallel fl at surfaces of the hinge pin
with the arrow on the hinge bushing, making sure
the purple mark is facing the arrow. Turn the closer
pin on the right door counterclockwise and the one
on the left door clockwise.
With the pin set properly in this location, the door
can now be remounted on the lower hinge with the
door 90 degrees to the cabinet.
To Next Page
Loading...
Need help?
General
