About the controls with temperature settings.
Not all features are on all models. Your controls will look like one of the following:
4
f
IiEs'.=]
III/
Cubed Crushed water
[ %_i']
Adjust
_HoldSsec
to Lo_k Co_ltoJ}
Location of Dispenser Controls
Location of Internal Controls
Dispenser Models
Internal Control Models
NOTE:Therefrigerator is shippedwith protective film covering the temperature
controls, tf this film was not removed during installation, remove it no_z
Thetemperature controls are preset in the factory at 38°F for the refrigerator
compartment and -2°F for the freezer compartment. Allow 24 hours for
the temperature to stabilize to the preset recommended settings.
Thetemperature controls can displag both the SET temperature as well as
the actual temperature in the refrigerator and freezer. Theactual temperature
mag var_tslightlg from the SET temperature based on usage and operating
environment.
FAdjustS/
reezerJ
rigerat_
Changing the Temperature
Dispenser models:
Tochange the temperature, press and release
the Adjust Freezeror Adjust Refrigerator pad,
Thedisplagwill show the actual temperature,
Tapeither the Adjust Freezeror Adjust Refrigerator
pad until the desiredtemperature is displaged.
Oncethe desiredtemperature has been set,
the temperature display will return to the actual
refrigerator and freezer temperatures after
10seconds.Severaladjustments mag be required.
Eachtime gou adjust controls,allow 24 hours
for the refrigerator to reach the temperature gou
have set.
Internal control models:
Tochange the temperature, pressand release
the Freezeror Fridge pad.Thedisplag will show
the actual temperature. Tapeither the Freezeror
Fridge pad until the desiredtemperature is displaged.
Once the desired temperature has been set,
the temperature displag will return to the actual
refrigerator and freezer temperatures after
10 seconds. Several adjustments mag be required.
Each time you adjust controls, allow 24 hours
for the refrigerator to reach the temperature
you have set.
4
To Next Page
Loading...
