GE Sievers 500 RL - Step 1: Unpack and Inspect the Analyzer

GE Analytical Instruments ©2010 46 of 226 DLM 74001-04 Rev. A
Chapter 3: Installation
Step 1: Unpack and Inspect the Analyzer
Open the shipping box and remove the Analyzer from the packaging. You may find it easiest to open the box and
remove the accessories tray, and then set the box on its side before removing the Analyzer from the box.
Next, verify that all items are present:
1. Sievers 500 RL On-Line TOC Analyzer
2. Operation and Maintenance Manual
3. Validation Support Package (VSP) Volume I
4. Sievers 500 RL Quick Start Guide
5. Accessories included:
• 1/4" sample inlet tubing with in-line filter (60 micron)
• 25/32" clamp for 3/4" waste tubing
• 3/4" OD tubing for waste line
• Ferrite suppressor for use with 230 V configurations
• 9/16" open-end wrench
• Double-ended screwdriver
•John Guest tool
• Stainless steel metric tubing converter (1/4-in-to-6-mm tube)
• Water bottle (250 mL) with nozzle for filling DI water reservoir
• Tray (for draining DI water cartridge)
• USB flash memory drive
• PVC conduit connector (“strain relief” hubs) for conduit wiring
• Sealing washer for PVC conduit connector
• Terminal ring for AC conduit ground wire, 16-14 American Wire Gauge (AWG)
•Grounding wrist strap
•Keys (2)
• Adhesive clips (2), for double-ended screwdriver and John guest fitting removal tool.
6. Certificate of Calibration
7. DataGuard activation key (optional)