GE Simon 60-875 - Page 68

Simon Security System
60
6. Interior sirens and speakers sound transmission beeps and a voice announcement
identifies the tripped sensor. Each beep represents one RF packet. Count the num-
ber of beeps and refer to the “Minimum Beeps” table for minimum requirements.
After the beeps, the panel announces, Sensor Name is activated, sensor status is XX
(XX = number of RF packets). The system will continue to prompt for sensors that
have not yet been tested. When all sensors have been tested the panel will
announce, Sensor test complete, press DONE.
Note
If a sensor does not meet
the minimum transmission
beep requirements, refer to
the “If a Sensor Fails the
Sensor Test” section of this
manual
7. Press DONE. The panel announces, Sensor Test OK.
8. If Cancel or DONE is pressed and the panel has not heard from all sensors, the
panel will respond, Sensor test canceled or failure.
Water Press a wet rag or wet finger over both of the round,
gold-plated terminals on the underside of the detector.
Carbon Monoxide Alarm Unplug the CO Alarm. Plug it back in, wait 5 seconds,
then press the TEST/RESET button until the unit
beeps 8 times.
Glass Guard Tap the glass 3 or 4 inches (8 cm) from the sensor.
Motion Sensor Avoid the Motion Sensor field of view for 5 minutes,
then enter its view.
Rate-of-Rise Heat Detector Rub your hands together until warm, then place one
hand on the detector for 30 seconds.
Shock Tap the glass twice, away from the sensor. Wait at
least 30 seconds before testing again.
Smoke Press and hold the test button until the system sounds
transmission beeps.
Personal Help Button Press and hold the help button until the light blinks and
the panel sounds al least 7 beeps.
KeyChain Touchpad Press and hold LOCK and UNLOCK simultaneously
for 3 seconds.
Remote Handheld Touch-
pad / QS1500 Keypad
Press and hold the 2 EMERGENCY buttons simulta-
neously for 3 seconds.
RF Electronic Thermostat /
DTIM
Automatically tested when sensor test begins.
Sensor Tripping Instructions
Sensor Do This
Minimum Beeps
Type of Sensor Number of Beeps
Wireless Intrusion Sensors 7–8
Wireless Smoke & Heat Sensors 7–8
Wireless Environmental/Personal Help Buttons 7–8
Hardwire Loops, RF Thermostat, DTIM 1
Emergency Buttons (Remote Handheld Touchpads only) 7-8