38
About the exhaust feature.
Charcoal Filter (on some models)
The charcoal filter cannot be cleaned. It must be
replaced.
For JVM1800 and JVM3600 Series models, order
Part No. WB2X10733 from your GE supplier.
For JVM2000 Series models, order Part No. WB2X10956
from your GE supplier.
If the model is not vented to the outside, the air
will be recirculated through a disposable charcoal
filter that helps remove smoke and odors.
The charcoal filter should be replaced when
it is noticeably dirty or discolored (usually after
6 to 12 months, depending on hood usage). See
“Optional Kits”, page 10, for more information.
To Remove Charcoal Filter
To remove the charcoal filter, disconnect power
at the main fuse or circuit breaker panel or pull
the plug.
Remove the top grille by removing the screws on
top of the grille that hold it in place and sliding the
grille to the left (opening the door makes grille
removal easier). Slide the filter towards the front
of the oven and remove it.
Remove grille screws
to remove the grille.
To Install Charcoal Filter
To install a new filter, remove plastic and other
outer wrapping from the new filter.
Insert the filter into the top opening of the oven as
shown. It will rest at an angle on 2 side support tabs
and in front of the right rear tab. Replace the grille
and screws.
Safety InstructionsOperating InstructionsTroubleshooting TipsConsumer Support
To Next Page
Loading...
Need help?
General
