—
Care and Cleaning (continued)
Light bulb replacement
In Fresh Food Compartment
1. Unplug refrigerator.
2. To align the control knob
properly, note position of
numbered control for proper
reassembly and pull off knob.
3. Pull bottomof light panel down
about 1/4“-just enough to disengage
lip at rear from grooves in retainers
on rear wall.
4. Lift panel to disengage top from
pins on side walls; remove panel.
After replacing with same size
bulb, reinstall panel (hang top on
pins; pull bottom down, push it
back and release it to let lip engage
grooves in retainers). Replace
temperature control knob in OFF
position, turn it to previous setting,
and plug refrigerator back in.
In Freezer Compartment
1. Unplug refrigerator.
2. Remove shelfjust below light
shield. (Shelf will be easier to
removeif it is emptied first.)
3. Pull plastic light shield toward
you. (Itwill bendto freetabsfrom
grooves.)
When you goon vacation
Forextended vacations or
absences, shutoffpowerto
refrigerator,turnthenumbered
controlto OFF, clean interior with
baking soda solution of one
tablespoon of soda to one quart of
water. Wipe dry. Toprevent odors,
leaveopen box of soda in
refrigerator. Leave doors open.
For shorter vacations, remove
perishablefoods andleavecontrois
atregularsettings.I+owever,if
roomtemperatureis expectedto
dropbelow 60”F., follow same
instructionsas forextended
vacations.
--
When you move
Disconnect power cord from wall
outlet, remove all food and clean
and dry the interior.
Secure all loose items such as
grille, shelves andstoragepansby
tapingthem securely in place to
preventdamage.
Be sure refrigerator stays in upright
position during actual moving and
in van. Refrigerator must be secured
in van to prevent movement. Protect
outside of refrigerator with blanket.
Move icemaker feeler arm to OFF
(up) position and be sure to shut off
water supply to the refrigerator.
,.
i
.. -
--.
0
After replacing with same size
bulb, reinstall shield and shelf and
plug refrigerator back in.
To Next Page
Loading...
Need help?
General
