Shelf Positions
C
..
3. Pull the drawerpart-wayout.
Reachin, push the rearof theglass
up and, at the same time, push it
back until it clears the front comer
retainegs.
4. Tilt and remove the cover.
5. Pull the drawer forward, lift the
front to clear stops, and removethe
drawer. If the refrigerator door
doesn’t open completely, pull the
drawer out until it hits the door.
Then lift the drawer up until it is
higher than the drawer supports,
tilt it and take it out.
h If tape holds Convertible Meat
Fan coverto dmwer supports,
removethe tape. Pull drawer
partway out. Reach in, push the
rear of the glass up and, at the same
time, back, until it clears front-
comer retainers.
7. Tilt and remove the cover.
& Tilt and remove the drawer.
After cleaning, replace in reverse
order.
9. Reinstall the gasket at the rear of
the Moist ‘n Fresh drawer. Fit the
end of the plastic drawer support
into the slot on the gasket, with the
rubber gasket flap fhcingyou. Make
sure the gasket snaps into place.
Sealed Snack _Pack
i
I
I
The Sealed Snack Pack-and
shelf to which it is attached-can
be relocated within the Fresh Food
compartment. The sealed drawer
retains high humidity for convenient
storage of meats and cheese, bacon,
hors d’oeuvres, spreads and snacks.
11
How to Rearrange
YourShelves
Ad@stableShelves
Shelves in the fresh food and
fi=eezercompartmentsare adjustable,
enabling you to make efficient shelf
arrangements to fit your family’s
fd storage needs.
lkmpered Glass Shelves in
Ikesh Food Compartment
❑
To remove shelves: Tilt shelf up
at front, then lift it up and out of
tracks on rear wall of refrigerator.
pll
,p,ug~p+
❑ E gage
~ Lower to
I
lock into place +11 ~,z
I 11411
To relocate shelves: Select desired
shelf height. With shelf front raised
slightly, engage top lugs in tracks at
rear of cabinet. Then lower front of
shelf until it locks into position.
To Next Page
Loading...
Need help?
General
