GeneralEkctric Fwd-Saver System
Moist ‘nFresh Drawer
The top drawer is designed to keep
unwrapped f- fresh by retaining
the natural moisture contentof fbods
such as:
● A~_
● Chem
● Plums
● Asparagus
● ~rn
● Radishes
● w, top~ ● cum
● ~u~
● Blueberries
● G~nq ~~ ● $j~~
● ~~
●-
● To~oeq
● Celery
● *&
ripe
● Was,green
As
in any refrigerated storage area,
itisrecommended that odorous
foods be stored Wrapped-fds
such as:
● B-1
● Cabbage
● Parsnips
● Brussels
● ~~-
● Turnips
sprouts
● G~ ~~
Storage time will depend upon the
type of food and its condition when
placed in the drawer.
Excess waterwhich may accumulate
in the bottom of the Moist ‘nFresh
drawer should be poured out and
the drawer wiped dry.
The Moist ‘n Fresh drawer is
partially sealed by gaskets attached
to the cover at the front and back
edges. Always push the dmwer all
the way in.
Moist‘nFm@t
drawer-
closetightiy—
Convertible
MeatKsq3er—
/
ConvertibleMeat K&per
The Convertible Meat Fan drawer
has its own cold air duct to allow a
stream of cold air from the freezer
compartment to flow around the
drawer.
The variable temperature control
regulates the air flow from the
freezer compartment.
Iliu
1. i
DrawerRemoval
b.’..-— . . . ..— -— -
.—— -—-
-4 -- 1-
Setcontrol lever to MEAT–the
coldest setting-to store fresh meats.
If lever is left in meat position for a
long period of time, some frost may
form on the inside of the drawer.
Set control lever to VEG to convert
the drawer to normal refrigerator
temperature and provide extra
vegetable storage space. Cold air
duct is turned off.
Drawers will stop before coming all
the wayout of refrigerator to heip
prevent contents from spilling onto “*
floor. Dmwm can easily be rmnoved ~
by tilting up slightly and pulling
~.
past “stop” location.
To remove drawers when the
fresh fd compartment door
cannot @ openjxi fully:
1. Remove fd from the shelf
abovethe Moist ‘nFresh drawer and
take out the shelf. Take food off of
the glass coverand out of the drawer.
Variable settings between these
extremes can be selected.
2. Remove the flexible gasket at
the rear of the Moist’n Fresh drawer.
Lift each end straight up until the
slots on the gasket are free of the
drawer support tabs.