Revision A Transport Pro 8-13
2012659-042
Disassembly: FRU Replacement
Inverter PCB
1. Remove the back plastic. See “Back Plastic Assembly” on page 8-6.
2. Remove the display subassembly. See “Display Subassembly” on
page 8-7.
3. Remove the two screws holding the inverter board on the shield.
4. Remove the backlight friction connector from the main processor
PCB.
5. Install the new inverter board onto the shield.
6. Connect the backlight friction connector.
7. Secure the inverter board to the main processor PCB with the two
screws (PN 2000540-007).
8. Reinstall the display subassembly. Be sure to reconnect the backlight
friction, keypad PCB and display friction connectors to the main
processor PCB.
634A
635A
To Next Page
Loading...
