optio,s
Thelight abovefl?eselected pad will be ONto irrdicate which OPTIONhas been selected,
H! TEMP Turnsoilthe heaterin all postrinseandfinal rinsecyclesto helppreventspotting
RINSE on dishware.ThisoptionmaybeturnedONor OFFduringthe wash cycle.
H! TEMP Energizestl_eIleaterto boostwatertemperaturein all prewashand mainwash fill
WASH cycles.Recommendedfor usewith heavilysoileddishes.Optionmaybeturned ON
or OFFduringthewash cycle.
HEATEDDRY Shutsoff tl_edryingheatoption.Dishesair drynaturallyand energyis saved.You
OFF canpropthe dooropenafter the CLEANlightilluminates.
HEATEDDRY Turnsthe heateron for fast drying.Thiscyclewill extendthe time toyour wash
ON cycleby30 minutes.NOTE:Cannotbe selectedwith RINSE ONLYcycle.
LOCK WhentheLOCKpadistouchedtwice within3 seconds,allpadsbecomeinoperative.
Yeacanlockthe_ntro/s to preventanyse/ectiunsfrombeingmade Oryeacan/oc_tile
controbafteryet/havestartedacycleorselectedBELAYSTARTsottlecycleorBELAY
STARTisnotioterropted
Children cannot accidentafly start dishwasher by touching pads with this
option selected.
Tounlockthe dishwasherafterit hasbeenlocked,touchtheLOCKpadh#icewithin
3seconds.ThelightabovetheLOC/(padwill turnoff.
BELAYSTART
Youcandelaythe start of a wasll cyclefor up to 8 hours.PresstheBELAYSTART
pad to choosethe numberof hoursyouwant to delaythe start ofthe cycle.The
machinewill countdownandstartautomaticallyatthe correcttime. Pressin9 the
START/RESETbutton will cancel the BELAg STARTselection.
NOTE:if youforgetto latclltile doora remindersignalwill beepuntil you doso.
RESET Tochangea cycle afterwashing starts,touchthe START/RESETpadto cancel
the cycle.After water ispumpedout and themotorstops,you canreprogramand
restarttile dishwasher.Thiswill takeapproximately90 seconds.
Close and latch the door. Touch the START/_ESETpadto begin the cycle. Water
till begins and approximately 40 seconds later the wash action begins.
NOTE: The dishwasher remembers )our last cTcle so )ou don't have to reprogram
each time. When the dishwasher is loaded and the door latch is in the locked
position, the control panel lights will be ONand display the last settings )ou
selected.
ltyou don't want to change any oI the settings, simpl} touch the START/RESET
pad to begin the cycle.
Also, ifa power t_filum occurs, NORMALand HEATEOORYwill automatically be
progq'ammed. Make any new selections and touch the START/RESETpadto begin
the Qvle.
This light is illuminated when a wash cs(le is complete. The light will sta) ON
until the door is opened.
iiii iiH!
!i ii iii iiiiii!
iili!i!i!i,liliii
9
To Next Page
Loading...
