Performing an Exam
3-10 Venue 50 – Basic User Manual
Direction 5446729-100 English
Rev. 7
Needle
Press to activate the Needle mode. Gain, Angle and Tilt can be activated.
The needle function only applies to linear probes.
Caution: Before activating the Needle, please make sure to select Interventional
related preset first.
Split Press to split the screen into two.
Zoom Press to magnify the region of interest.
Guide Press to display the biopsy guidelines.
Configurable
Parameters
• LiveGain: To balance echo contrast so that cystic structures appear echo-free and
reflecting tissue fills in.
• Frequency: This optimizes the probe’s wide band imaging capabilities at multiple
frequencies to image at greater depths.
• CrossXBeam: Improve contrast resolution with increased conspicuity of low
contrast lesions, better detection of calcifications, biopsy needle visualization, and
cystic boundary definition.
• Gray Map: Affects the presentation of B Mode information.
• Focus Pos: Focus optimizes the image by increasing the resolution for a specific
area.
• Reverse: Used for anatomical correctness.
• ATO Level: Select the Auto Tissue Optimize Level to pick a preference for the
contrast enhancement in the resulting image.
• Dynamic Range: It is useful for optimizing tissue texture for different anatomy.
• Compression: Suppress the noise in the image.
• Rejection: Allow for the elimination from the display of low level echoes caused by
noise.
• Frame Aver: Smooth the image.
• SRI HD: Smooth the image when image speckle interferes with the desired image
detail
• Edge Enhance: Make the image edge clearer/sharper.
• FOV: Adjust field of view
• AO: Adjust acoustic output
Note: The configurable parameters can be configured in Utility -> Settings -> ScanConfig.
Table 3-1: B Mode Controls
Controls Affect on Image
To Next Page
Loading...
