Care and Maintenance
10-14 Venue 50 – Basic Service Manual
5447566-100 English Rev. 7
Physical inspection
NOTE: These features may not be present on all Ultrasound systems.
Optional Diagnostic Checks
Optionally you can access the diagnostic software as described
in Chapter 7. View the error logs and run desired diagnostics.
View the Log
1. Review the system error log for any problems.
2. Check the temperature log to see if there are any trends that
could cause problems in the future.
Table 10-9: Physical checks
Step Item Description
1. Labeling Verify that all Ultrasound system labeling is present and in readable
condition.
2. Scratches & Dents Inspect the exterior for dents, scratches or cracks. .
3. Input Power Refer to: ‘Mains cable inspection’ on page 10-13.
4. Cables &
Connectors
Check all internal cable harnesses and connectors for wear and secure
connector seating. Pay special attention to footswitch assembly and probe
strain or bend reliefs.
5. Shielding &
Covers
Check to ensure that all EMI shielding, internal covers, air flow panels and
screws are in place. Missing covers and hardware could cause EMI/RFI
problems while scanning.
6. Control Panel Inspect control panel. Note any damaged or missing items.
7. Control Panel
Lighting
Check for proper operation of all operator panel light.
8. External I/O Check all connectors for damage.
9. Power and
System Status
Indicators
Check for proper operation of all Power and System Status Indicators.
10. Battery Where applicable, check that the battery is not damaged, does not leak,
does not emit an odor, and is not deformed or discolored. Observe all
warnings and cautions for battery handling, recharging, storing, and/or
disposal, as listed in ‘Battery Safety’ on page 1-21.
To Next Page
Loading...
