DIRECTION 5854713-100, REVISION 2 VENUE FIT™ SERVICE MANUAL
8-36 Chapter 8 - Replacement Procedures
PRELIMINARY
8.) Route the power cable through the handle.
9.) Open only the top velcro strap and remove power supply.
8-2-16-5
PSU Installation Procedure
1) Install the PSU into its compartment and secure with scotch straps.
2) Route the power cable through the handle and the pole.
3) Secure the cable with the cart cable guide.
4.) Route the cable through the tilt cable holder and connect to the system..
Figure 8-61 Disconnect Cable underneath Power Supply
Figure 8-62 Remove Power Supply
Perform the checks listed in Tab l e 8-3 6 - Cart Cables section
To Next Page
Loading...
