DIRECTION 5854713-100, REVISION 2
VENUE FIT™ SERVICE MANUAL
3-22 Chapter 3 - System Setup
PRELIMINARY
On the Network tab, define the required settings and tap Save.Then, proceed to the next tab.
Figure 3-10 Venue Fit™ Installation Wizard - Network Tab
On the Printer tab, configure the printer and tap Save. Then, proceed to the next tab. If the printer is
already configured, skip this step and proceed to the next one.
Figure 3-11 Venue Fit™ Installation Wizard - Thermal Printer Tab
On the InSite tab, define the required settings and tap Submit Changes. Make sure you fill all mandatory
fields (highlighted in bold). Then, proceed to the next tab
Figure 3-12 Venue Fit™ Installation Wizard - RSVP Tab
To Next Page
Loading...
