D
IRECTION 5813707-100, REVISION 2 VENUE™ SERVICE MANUAL
8-6 Chapter 8 - Replacement Procedures
PRELIMINARY
3) Release 10 captive screws.
Note: IMPORTANT! Ensure the screws are fully released before removing the cover, to avoid
damaging the touch display screw heli-coils.
4) Gently separate the back cover from the touch display panel starting at the top left corner
proceeding clockwise.
8-2-3-5 Back Cover Installation Procedure
1.) Attach the back cover to the front panel and tighten the 10 captive screws in the following order:
• Tighten screws 1 thru 4 in the following order: first tighten screws 1 and 3; then tighten screws
2 and 4 (diagonal order)
Figure 8-74 Releasing 10 captive Screws
Figure 8-75 Removed Back Cover
To Next Page
Loading...
