D
IRECTION 5813707-100, REVISION 2 VENUE™ SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-27
PRELIMINARY
7.) Remove the unit.
8-2-9-5 C
-FEB Heat Sync Assembly Installation Procedure
1.) Remove the protective nylon sheet cover from the new unit.
2.) Insert the C_FEB. Note the rail on the left side.
3.) Secure the 5 screws.
4.) Connect the Fan cable and the Display Indicator (green) cable connectors.
5.) Rout the fan cable and the front display indicator cables through the left plastic clip holding and
secure the clip.
6.) Install the Fan.
7) Install C-PSB.
8.) Install back cover.
Figure 8-105 Remove the C-FEB
• Fan Installation Procedure
• C-PSB Installation Procedure
• Back Cover Installation Procedure
To Next Page
Loading...
