Peripherals Installation
Versana Balance – Basic Service Manual System view 3-31
5808768-100 English Rev.9
3-8-3 Peripherals Installation Instructions
3-8-3-1 Sony UP-D898MD Printer Installation
3-8-3-1-1 Tools
Common Phillips screwdrivers
3-8-3-1-2 Manpower
One person 20 minutes + travel.
3-8-3-1-3 Preparations
1. Unpack B/W Printer.
2. Ensure no physical damage.
3. Shut down the system and disconnect the power cord.
3-8-3-1-4 Installation Procedure
NOTE: The printer driver is customized for the Versana Balance at the
factory, you do not need to change the settings.
1. Put the AC printer shelf on the bottom of the printer, and
then screw 4 screws to fix the printer shelf.
Figure 3-7. Install printer to printer shelf
To Next Page
Loading...
