General procedures
Versana Balance – Basic Service Manual System view 4-9
5808768-100 English Rev.9
4-2-3 Power off(continued)
• Shutdown
Use this button to shut down the system. The entire system
will shut down. It is recommended to perform a full shutdown
at least once a week.
If the Shutdown button is dimmed, use the key-combination
<Ctrl+Alt+Delete> to shut down the unit.
NOTE: To enable the key-combination <Ctrl+Alt+Delete>, the
dongle should be connected to the system.
• Cancel
Use this button to exit from the System-Exit menu and
return to the previous operation.
4-2-3-1 System shutdown
Disconnect the Mains Power Cable is necessary. For example:
Relocating the scanner.
DO NOT unplug and/or transport the unit until after the power
off sequence has been completed. Failure to do so may result
in corrupted patient files.
To Next Page
Loading...
