Scan Assistant
Versana Essential – User Guide 2-41
5759238-100 English Rev. 2
Setting up Scan Assistant (continued)
You can access the Scan Assistant Creator to edit the exam’s
program from the imaging display via the Creator Icon located at
the bottom of the Scan Assistant Program monitor on the
display. You can activate the Scan Assistant Creator from the
image screen, make edits, and then run Scan Assistant to test
your changes.
NOTE: If you edit the program after you have already stored several
images, and your edits change the number of program steps,
you are prompted to Restart or Continue the Scan Assistant
program.
NOTE: If you edit the program after you have already completed several
steps, checkmarked steps remain checkmarked, even if you
insert a new step between checkmarked steps. If this is not
correct, you can edit the checkmarks or restart the program.
To Next Page
Loading...
