System Start-Up
Versana Essential – User Guide 1-39
5759238-100 English Rev. 2
Crash Recovery Instructions
In cases where the system detects an internal error, the system
may reboot on its own. If this happens, the system automatically
returns to the start-up screens. All images and measurements,
except for generic reports, are preserved in the system.
The system automatically ends the current exam and
permanently store all the images and measurements. When the
system reboots, check that all images and measurements have
been preserved in the system. Then, simply hold down the
power switch to initiate a normal power down sequence.
NOTE: If the image is not updated properly when the system is up, shut
down the system again.
NOTE: Generic reports are not saved if the system crashes before you
save it.
The system crash may cause the internal HDD corruption.
Avoid using the internal HDD as a permanent storage device.
Backup data on a regular basis.
To Next Page
Loading...
