GE MEDICAL SYSTEMS
D
IRECTION FK091075, REVISION 04 VIVID 3N PRO/EXPERT SERVICE MANUAL
Chapter 7 Diagnostics/Troubleshooting 7-15
7-3-4 VME Bus (VME) Diagnostic Tests( RFT Configuration)
The VME Bus diagnostic test checks the communication on the VME Bus between the IP card, the FEC
and the RFT.
NOTE: Before performing the VME Bus test, perform the IMP test, as described in 7-3-3 "Image Port
(IMP) Diagnostic Tests" on page 7-13. If the VME Bus test is performed without first performing
this test, and errors are identified, you must perform the IMP test to ensure that the VME board
is the source of the error.
1) Access the FE Diagnostics dialog box, as described in 7-3-1 "Accessing the Front End Diagnostic
Options" on page 7-6.
2) In the FE Diagnostics dialog box, trackball to the VME tab and press Select,
OR
Trackball to the VME button in the Data Flow Map and press Select.
The VME tab is displayed, as shown below:
Figure 7-8 VME Tab - FE Diagnostics Dialog Box
Data Flow Map
Test Description Area
Test Area
Comment Area
Tabs
To Next Page
Loading...
