GE MEDICAL SYSTEMS
D
IRECTION FK091075, REVISION 04 VIVID 3N PRO/EXPERT SERVICE MANUAL
8-8 Section 8-2 - Cover Replacement Procedures
8-2-5 Connector Panels Cover Replacement Procedures
8-2-5-1 Tools
Use the appropriate Phillips-type screw drivers, in indicated in the connector panels cover replacement
procedures.
8-2-5-2 Preparations
Shut down the Vivid 3N Pro/Expert ultrasound unit, as described in Chapter 3 - Installation.
8-2-5-3 Connector Panels Cover Removal Procedure
1) Remove the two screws, located one on either side of the cover.
2) Lift and remove the cover.
Figure 8-8 Connector Panels Cover
8-2-5-4 Connector Panels Cover Installation Procedure
1) Return the cover to its original position above the connector panels.
2) Insert the two screws, located one on either side of the cover, and tighten them firmly.
To Next Page
Loading...
