GE MEDICAL SYSTEMS
D
IRECTION FK091075, REVISION 04 VIVID 3N PRO/EXPERT SERVICE MANUAL
Chapter 8 Replacement Procedures 8-11
8-2-6-3 Top Cover Lower Section Removal Procedure (cont’d)
9) Remove the section of the collar released in the previous step, leaving an open gap at the rear of
the top cover, as shown below:
Figure 8-12 Top Cover with Collar Removed
10) Remove the four screws that secure each connector panel to the top cover.
11) Gently pull the rear panels backwards, leaving them hanging loosely on their cables, as shown
below:
Figure 8-13 Connector Panels - Loosened
12) Remove the two screws securing the rear section of the gas spring cover, and then remove this
cover.
To Next Page
Loading...
