GE MEDICAL SYSTEMS
D
IRECTION FK091075, REVISION 04 VIVID 3N PRO/EXPERT SERVICE MANUAL
Chapter 8 Replacement Procedures 8-103
8-6-6-5 Up/Down Handle Replacement Procedure (cont’d)
4) Mount the handle mounting brackets onto the chassis using one long and one short screw for each
bracket, as shown in Figure 8-87. Tighten the screws to secure the brackets firmly in position.
Figure 8-86 Fitting Gas Spring Cable to Up/Down Handle
Figure 8-87 Mounting the Brackets onto the Chassis
Securing Nut
Up/Down Handle
Gas Spring Cable
Retaining Bracket
shown in detail
Grooved Hole
(insert cable here)
Gas Spring Cable
Short Screw
Long Screw
Short Screw
Long Screw
To Next Page
Loading...
