GE MEDICAL SYSTEMS
D
IRECTION FK091075, REVISION 04 VIVID 3N PRO/EXPERT SERVICE MANUAL
8-152 Section 8-8 - Peripherals
8-8-5-4 Sony UP-21MD Color Video Printer Installation - Procedure1 (cont’d)
22.)Re-install the Connectors Panels Cover as described in 8-2-5-4 "Connector Panels Cover
Installation Procedure" on page 8-8.
23) Reconnect the mains AC power cable from the wall outlet.
24) Turn ON the main circuit breaker located on rear of the Vivid 3N.
25) Turn ON the Vivid 3N by pressing the ON/OFF button on the Control Console.
26.)Select the activation key under System Configuration, VCR/ECG Tab, A/B Swap.
By default, Print B key will be B&W Video printer and Print A key will be Color Video printer. For
more information on switching printer settings, see 3-8-9 "VCR/ECG Tab" on page 3-44.
8-8-6 Sony UP 21MD Color Video Printer Removal - Procedure 1
NOTE: This procedure (Procedure 1) is for units that are equipped with a previously-installed B&W printer and a
VCR. The color printer option includes a metal shelf and fastening belt on which the color printer is placed.
1.) Unlock the belt buckles securing the color printer.
Figure 8-140 Belt Buckles Securing Printer
2.) Move the color printer sideways, to gain access to the rear panel.
3.) Open the lower middle screw from the color printer’s rear panel and remove the Ground cable lug.
4.) Unplug the AC cable.
5.) Unplug the BNC connectors R-G-B and SYNC from the color printer.
6.) Remove the color printer from the top shelf.
Note: Perform the following steps only if the metal shelf must be removed.
7.) Remove the right and left screws located in the legs on either side of the shelf, and remove the shelf.
Note: Do not perform the following step if the metal shelf will later be replaced.
8.) Return and fasten the two screws (removed in step 7) to either side of the top cover.
Belt Buckles
To Next Page
Loading...
