GE MEDICAL SYSTEMS
D
IRECTION FK091075, REVISION 04 VIVID 3N PRO/EXPERT SERVICE MANUAL
Chapter 3 Installation 3-25
3-6-2-2 Connecting the VCR
1) Place the VCR on the peripheral tray and connect the following:
2) Install the VCR according to the VCR installation schematics, see Figure 8-123 "Belt Buckles
Securing Printer" on page 8-139.
3) After connecting the remaining peripherals and switching the system on, configure the VCR
settings, as described in 3-8-9 "VCR/ECG Tab" on page 3-44.
3-6-2-3 Connecting the Black & White Printer
1) Place the printer on the peripheral tray and connect the following cables as shown in Table 3-17.
2) Install the printer according to the printer’s installation schematics, see Figure 8-123 "Belt Buckles
Securing Printer" on page 8-139.
3) After connecting the remaining peripherals and switching the system on, configure the printer
settings, as described in 3-8-8 "Printers Tab" on page 3-42.
Table 3-16 VCR Cables
From the VCR To the Left Panel DIP on VCR Right Panel
S-Video IN S-Video OUT (Y/C OUT) 1-4 OFF (down)
S-Video OUT S-Video IN (Y/C OUT) 5-6 ON (up)
Audio IN Audio OUT
Audio OUT Audio IN
BE Control (RS-232) VCR RS 232 (1)
Table 3-17 Black & White Printer Cables
From the Printer To the Left Panel
Video IN Composite Video OUT B/W
External Trigger Print Trigger
Power Cable Right Connectors Panel AC outlet
To Next Page
Loading...
