(Scan Assist Pro – cont.)
7. Continue to add additional steps by using icons located on left of steps.
Tip: new steps added will need to be edited in all fields: Imaging, comments,
measurements, etc.
8. Once all steps are completed, Select Save As on top menu
9. Prompt will appear on Rule Check, select OK and all conflicts will be
checked and resolved
10. Give new protocol a name
11. Select a category it will be placed under
12. Name protocol with extension file of .uep
Scan Assist Pro
(Scan Assist Pro – cont.)
13. Select OK, and exit creator
Note: to place new protocol on touch screen, select custom folder on left side
of menu
Select Category you would like new protocol to be under on right side of
menu, then highlight new protocol on left and press arrow indicating to move
to right side of screen.
14. Exit Creator screen by selecting config
15. Select Protocol and new protocol should be listed on touch screen under
new category and application you assigned it
To Next Page
Loading...
