(Scan Assist Pro – cont.)
Editing a current Protocol
1. Once in a protocol, to edit steps enter config from Scan Assist Pro tab
2. Select Edit from middle of menus
3. Scan Assist Editor will open
4. Select step you would like to edit
5. Use icons to the left of steps to do the following:
Scan Assist Pro
(Scan Assist Pro – cont.)
1. Delete step (X)
2. Move step up or down in the protocol (arrow up before
step, or down after the current step)
3. To insert a step above or below the current selected step,
use the top 2 icons with blue insert ion indicating before or
after the step
To Next Page
Loading...
