GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
3-160 Section 3-10 - Connectivity Setup
1) From the E-mail Dialog box, activate the Send Player Software check box:
2) Click Next.
3.) From the Email Address Window (Figure 3-169 on page 3-158), select the appropriate recipient
address from the drop-down menu, or type the address in the Send To field.
4) Click Next.
The E-mail (addressed to the selected addressee) with the MPEGVue Player software is sent to the
Outbox; during this operation a progress window is displayed (Figure 3-166).
When the operation is complete, a Confirmation window is displayed as shown in Figure 3-167.
5) Click OK to close the message window.
6) Check that the message has been sent from the Outlook Outbox.
NOTE: When the message has been sent from the Outbox and has arrived at the addressee, the
recipient should follow the instructions (included in the body of the email) in order to install the
MPEGVue Player.
First Time Receipt of MPEGVue Player Software and Images by E-mail
When a group of messages arrive by e-mail and the user wishes to review the exam by MPEGvue,
proceed as follows:
1) From Outlook, open the received email message containing the installation of MPEGVue Player
files (three attachments: MPEGVuePlayer.cab; Start.wmv; Setup.html). Right-click on each
attachment and select Save As to save them to the Desktop.
NOTE: Do not double-click on an attachment.
2) From the desktop, double-click on the icon.
Figure 3-172 E-mail Dialog Box - Sending Player Software
To Next Page
Loading...
