GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
7-82 Section 7-4 - Performing Front End (FE) Diagnostics
PRELIMINARY
7-4-6 Probe Select Board Diagnostic Tests (cont’d)
12.)Use the tools provided to scroll through the channels and view the results, as previously described.
13) When done, trackball to the Close button and press Set to close the View Report window.
14) Select the fourth report (Signal SNR); the report is highlighted in the Reports list, and the
corresponding results are shown in the Report window below, as shown in Figure 7-52 "View Test
Log - ACW BPF Test - BPF3" on page 7-83.
Figure 7-51 View Test Log - ACW BPF Test - BPF2
To Next Page
Loading...
