GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-120 Section 8-6 - Lower Section Components Replacement Procedures
PRELIMINARY
NOTE: The bracket cannot be removed completely at this stage as it still connected to the system via
the battery cable, as explained in the next step.
8.) Tilt the battery bracket sideways (swing it around), then disconnect the battery cable connector from
the BEP (Figure 8-149).
9.) Remove the battery bracket and tilt it upside down on the table surface (Figure 8-150).
10.)Remove the cable connector bracket by unscrewing the two cable connecting bracket retaining
screws.
Figure 8-148 Removing the Battery Bracket
Figure 8-149 Battery Cable Connected to the BEP
Figure 8-150 Battery Bracket Removed from the System
Battery Cable
Cable Connector
To Next Page
Loading...
