GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-229
PRELIMINARY
12) Perform the following changes in the <Boot>:
13) Save and exit BIOS Setup.
14.)Reboot the system and check that Supervisor PASSWORD was installed properly.
15.)Proceed to perform the following functionality tests:
-- “Software Configuration Checks” on page 4-45
-- “Calibration” on page 7-12
-- “Full System Test” on page 7-11
Option Value Comments
\Boot\ATX AC Power Boot Mode Desktop
\Boot\Boot Device Priority
\Boot\ Boot Device Priority 1 - st Boot device
CDROM Drive
Highlight CDROM Drive, Hold
Shift Button and Press “+” to move
to upper position
\Boot\ Boot Device Priority 2 – nd Boot device Hard Drive
\Boot\ Boot Device Priority 3 –rd Boot Device
Removable Devices
\Boot\ Boot Device Priority\Network Boot
\Boot\Display Control\LCD Brightness
255
Hold Shift and press “+” button to
set value
To Next Page
Loading...
