GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-252 Section 8-8 - Software Loading
PRELIMINARY
3) Adhere each gasket adjacent to the rear screw on both sides of the printer as shown in
Figure 8-288. Ensure that the vent holes are not covered by the gasket.
4) Re-install the B&W printer, as described in the “Black and White Printer Removal Procedure” on
page 8-247.
5) Re-install the DVD/CD-RW drive, as described in the “DVD/CD-RW Installation Procedure” on
page 8-238.
6) Return the Vivid S5 N or Vivid S6 N left and right rear covers, as described in the “Left Rear Cover
Installation Procedure” on page 8-16 and “Right Rear Cover Installation Procedure” on page 8-12
7) Return the Vivid S5 N or Vivid S6 N front cover, as described in the “Front Cover Installation
Procedure” on page 8-19.
8) Return the Vivid S5 N or Vivid S6 N left and right side covers, as described in the “Left Side Cover
Installation Procedure” on page 8-7 and “Right Side Cover Installation Procedure” on page 8-5.
9.) Turn ON power to the system.
10.)Proceed to perform the following functionality tests:
- “Grounding Continuity” on page 10-23
- “Chassis Current Leakage Test” on page 10-24
To Next Page
Loading...
