Stress Echo
Vivid S5/Vivid S6 User Manual 199
R2424458-100 Rev. 2
Selection of a stress test protocol template
1. Press PROTOCOL to enter the stress echo mode.
The Protocol screen is displayed (see Figure 5-1) showing
the default stress protocol for the current probe.
To create or edit a
template see
page 225.
2. To use the current template:
Turn freeze off to initiate scanning.
To use another template:
Press the assignable
TEMPLATE.
The template list is displayed.
3. Trackball to the desired template.
4. Press
SET.
5. Turn freeze off to initiate scanning using the new template.
Figure 5-1: The Protocol screen
1. Projection selection
2. Level
3. Current acquisition
4. Projection
5. Group of views
To Next Page
Loading...
